VVHOOY Waterproof Mobility Scooter Cover
Oxford fabric cover of about 140 cm by 66 cm by 91 cm, a good match for many small boot and folding scooters stored outside.
A mobility scooter cover keeps rain, dust, leaves and bird droppings off your scooter when it is parked outside or in a shed, and it hides the scooter from passers by. The main things to get right are the fit, the strength of the fabric and how well the cover stays put in the wind.
Scooters are built to cope with a shower on the way to the shops, but they are not designed to sit in the rain night after night. Water can get into the controls, the seat foam and electrical connections, and sun fades plastics and cracks seat covers. A cover also keeps the seat dry so you are not sitting on a wet cushion, and it makes the scooter less tempting to thieves because they cannot see what is underneath. Many insurers prefer a scooter to be kept indoors, but a good cover is the next best thing if that is not possible.
Measure the scooter from the front of the basket to the back bumper, across the widest point, and from the ground to the top of the tiller or seat back, whichever is higher. Add a little to each figure so the cover goes on easily. Covers are usually listed in centimetres, and the size labels such as large or extra large vary between makers, so go by the measurements. A cover that is too tight strains the seams, while one that is far too big flaps in the wind and can blow off.
| Scooter Type | Typical Cover Length | Notes |
|---|---|---|
| Small boot scooter | Around 120 cm to 140 cm | Often fine with a lighter cover |
| Mid size pavement scooter | Around 140 cm to 160 cm | Check the height with the seat raised |
| Large road scooter | Around 160 cm to 190 cm | Look for heavy duty fabric and straps |
Most mobility scooter covers waterproof claims rely on a coated fabric, often oxford fabric with a denier rating, shown as a number followed by the letter D, that tells you how thick the yarn is. Higher ratings are usually tougher and last longer outdoors, though they are heavier to lift. Taped seams stop water creeping through the stitching. No cover is fully watertight in a gale, so park in a sheltered spot where you can and check the scooter after heavy rain.
A fully sealed cover can trap moisture underneath, especially when warm days are followed by cold nights. That condensation can be as bad for electrics as rain. Look for covers with vents, and on dry days lift the cover off for a while to let the scooter air. Avoid covering a scooter that is still wet from a ride, and wipe it down first if you can. A small moisture absorber under the seat can help over winter.
A tiller cover is a smaller cover that fits over the handlebars and control panel while you are out. It protects the key, the battery gauge and the switches from rain when you park outside a shop, and many have a clear window so you can still see the display while riding. It does not replace a full storage cover, but the two work well together.
Many covers have a reinforced hole or loop near the wheels, so a chain or cable lock can pass through the cover and the scooter frame. That stops the cover being lifted off without unlocking it, and stops the scooter being wheeled away. Covers in plain dark colours draw less attention than bright ones. For more ideas see our guide to mobility scooter storage, which covers sheds, stores and anchors.
Cold weather reduces battery range and can damage batteries left flat. If your scooter lives outside under a cover, bring the battery pack indoors to charge if it removes, or charge it in a dry shed or garage with a proper socket. Never charge under a cover outdoors, as chargers need air around them. Our guide to the mobility scooter battery explains charging and storage in more detail.
Brush off leaves and dirt before folding, and wash the cover by hand with mild soap if it gets grubby, as harsh detergents can strip the waterproof coating. Let it dry fully before storing. Check the seams and hem every few months, and replace a cover that has torn or lost its coating, as it will hold water against the scooter. If you also use a wheelchair, our guide to a wheelchair cover for storage looks at covers for chairs, and our scooter accessories guide covers other useful extras.
The covers below were in stock when we checked each listing. Compare the measurements with your scooter before ordering.
Many people do, but a shed, garage or scooter store is better for the electrics and for security. If it must stay outside, use a heavy duty cover and a lock.
Only if it is big enough. Measure the scooter with the canopy fitted, or fold the canopy down first.
Close to it, so rain does not blow underneath, but not so long that it gathers puddles.
No, a storage cover is only for parking. For riding in the rain, use a tiller cover and a cape or canopy instead.
Oxford fabric cover of about 140 cm by 66 cm by 91 cm, a good match for many small boot and folding scooters stored outside.
Thicker oxford fabric in a size of about 124 cm by 58 cm by 99 cm. Tougher than lighter covers for year round use.
A large cover of about 147 cm by 71 cm by 140 cm with a magnetic closure. Tall enough for scooters with a high seat back or canopy folded.
Waterproof cover with UV resistance and a storage bag, so it can travel with the scooter. Middle of the price range.
A heavy oxford cover of about 190 cm by 71 cm by 117 cm for larger pavement and road scooters.
An extra large all season storage cover from a UK brand of scooter accessories. The dearest here, aimed at big scooters kept outdoors.
Heavy duty oxford fabric at a fair price. A sensible choice for mid size scooters stored in a carport or under shelter.
A heavy polyester storage cover with a waterproof coating. Good value for its fabric weight.